Yankee PS-M2

The Yankee Ps-M2 (230V) is a professional power supply able to deliver both DC and AC power to your effects pedals. It has five fully isolated sections with up to 17 outputs. Includes a LED USB lamp and cables.

SKU: YAPS-M2 Categories: , ,


Out of stock

Notify me when product is back instock.


Output config:
Section I – 5 outputs, 9V DC, 1200 mA
Section II – 5 outputs, 9V DC, 1200 mA
Section III – 2 outputs SAG with variable DC voltage 1V – 10V, 600mA (Low battery simulation)
Section IV – 2 outputs with individual voltage regulation (6VDC, 9VDC, 12VDC, 15VDC, 18VDC and 24VDC), 600 mA
Section V – 3 outputs 9VAC + 12VAC + 14VAC, 2000mA

This power supply can feed virtually every effect pedal on the market
Ability to change the location of the power cable slot (up or back). This allows even greater opportunity to match settings for a specific pedalboard. Two options position can be seen in the pictures.
Toroidal transformer:
It has very good quality secondary voltage and significantly less distortion. When you use the AC adapter no hum is heard.
Voltage stabilizer:
It provides stable voltage independent of mains voltage fluctuations.
Effective filter Voltage:
Very effective filter allows you to power even the most sensitive guitar effects. Short-circuit protection
Circuit protection:
Disconnects the output of which is shorted. This is important because of the special nature of these services results. They are likely to + out and it happens, for example. During a concert that upon contact with the metal casing of the effect of a short circuit. In this case, disconnect the power supply to the output will not be burnt and turn on cessation of the circuit.
Protection against overheating:
The power supply was used high-current limiting circuit, overheating of the heat sink.
USB out and LED lamp
Input voltage: 230V / 50Hz
Dimensions: 52mm x 140mm x 105mm (H x W x L)
Weight: 1500g

Additional information

Weight 1 kg


Handmade in:


You may also like…